Permission is hereby granted, free of charge, to any person obtaining a copy of this software and associated documentation files (the "Software"), to deal in the Software without restriction, including without limitation the rights to use, copy, modify, merge, publish, distribute, sublicense, and/or sell copies of the Software, and to permit persons to whom the Software is furnished to do so, subject to the following conditions:
The above copyright notice and this permission notice shall be included in all copies or substantial portions of the Software.
THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE.
select a cubic, bended curve and hit "create cable" to create a polygon cable with the radius difined in the gui.
select the cable-geo and press: "-hi - make dynamic" to make the cable(s) dynamic with the amount of "devisions" defined in the gui. (higher values: good, but slow | lower values: poor, but fast)
"-low - make dynamic" makes the selected cable dynamic. only the cv's of the curve are used.
"make ends animatable" enables you to control the ends of the selected cable. make it stick or dynamic, based on the parameters of the cable geometry.
"delete rigg" freezes the cable as it is.
"turn cycle msg off" turn off the nasty cycle warnings control the cable with the following attributes in the cable-geo: mass damping place on curve (if you use "create cable from object", higher values correct the placement of the geo onto the curve) gravity (build-in field)