Permission is hereby granted, free of charge, to any person obtaining a copy of this software and associated documentation files (the "Software"), to deal in the Software without restriction, including without limitation the rights to use, copy, modify, merge, publish, distribute, sublicense, and/or sell copies of the Software, and to permit persons to whom the Software is furnished to do so, subject to the following conditions:
The above copyright notice and this permission notice shall be included in all copies or substantial portions of the Software.
THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE.
I am on Maya 2011 OS X and when I use RigHelper the root control is missing the Face Rig channel for joint-based facial controls. I also do not see channels for knee and elbow locks. I noticed these in your Rig Overview video #4. I followed your videos - am I missing a step?
Hey jquan8799,
it sounds like you ran the "Setup Rig" command without the facial rig and stretchy boxes checked. Note that if you reload rigHelper it defaults the facial rig and stretchy options to off.
I would suggest setting up the rig again and making sure those settings are checked.
jquan8799
Replies to this question:
Nick Dupree said over 11 years ago:
jquan8799 said over 11 years ago: